12
Ludlow Standard Model ECG
– Natural Gas
U
SING THE REMOTE CONTROL HANDSET
.
IMPORTANT USER INFORMATION
– READ THIS BEFORE ATTEMPTING TO OPERATE THE STOVE
NOTE
: The handset is paired to the fire during manufacture. DO NOT ALTER THE PAIRING.
For safety reasons, the handset is designed so as to avoid accidental operation. If, during proper use, the handset
fails to communicate with the valve there is a possibility that the pairing has been inadvertently altered
– in this
case the handset will need to be reset and re-paired with the valve.
For Normal Use:-
This stove comes with batteries fitted into the remote handset and also in the Gas Control
Valve (GCV). However if for any reason they have been removed then prior to using the stove for the first time
insert new, Quality alkaline, AA batteries into the valve and handset such as Energizer or Duracell, but DO NOT
USE rechargeable batteries . Ensure they are mounted firmly and in the correct orientation, and that the battery
covers are replaced fully. Ensure the small isolation switch on the
Gas Control Valve
is switched to the
ON
(I)
position.
4 Quick Steps to using the Remote to Turn the Stove ON &
Adjust the Flame/Heat settings
Step 1 -
Hold the handset as shown, wrapping your hand around the
handset to make good contact with both sides. The green unlock light
should illuminate, activating the buttons (if the light is not illuminated,
the buttons will not work).
Word PILOT Appears
Step 2 -
Press and hold the power button, release as soon as
PILOT appears on the display in the bottom Left Hand corner
(approx. 1-2 seconds). The fire will commence ignition
sequence. If successful, the fire will automatically go to
maximum heat output (MAX FLAME).
NOTE: Releasing the power button too soon or depressing for
too long after the PILOT appear in the bottom LH corner, will
cause the fire not to light because system assumes press to
be unintentional.
