18.
Connect electrical cable to a fused double pole switch, as described in General
Requirements.
Fuse Rating - 3 amps
Cable Colour Coding
Brown - Live
Blue - Neutral
Green/Yellow - Earth
19.
Locate the two stainless steel spring plates on the underside of the hob surface plate
glass. (See Fig. 12). The spring plates should be held loosely in place by the triangular
plates adjacent to each burner hole. Note the spark electrode position of each burner and
rotate the spring plates into approximately the appropriate position.
20. Lower the hob surface gently over the chassis. Adjust the spring plates until they fit
accurately over each burner. Secure hob surface plate with three securing screws. (See
Fig. 13). The two 50mm M3 screws should now be fitted through both the clearance hole
in the spring plates, and the hole in the triangular fittings on the underside of the hob
surface plate, and into the M3 nut on the burner mounting bracket. The 25mm M3 screw
fits through the hole in the metal bracket that is visible through the rear control hole into
the nut clipped to the tap mounting bracket. Ensure that the burners are central in the holes
in the glass. Tighten the three screws until the hob surface plate is adequately secure to
ensure a seal all round.
DO NOT OVERTIGHTEN.
IMPORTANT NOTE:
When assembling hob plate glass ensure that grommets around tap
holes
DO NOT
foul (push down) micro-switches on tap spindles.
Fig. 12
Fig. 13
DESN 513602
DESN 513603
11
Summary of Contents for FFD
Page 15: ...15...
