12
3. Hotcupboard installation
NOTE
: The Aga hotcupboard should arrive with the top plate in a jacked up position
(except for
induction top versions which will arrive with the top fully wound down)
. This is to allow the complete
appliance to be slid onto its plinth when alongside the AGA eR7 without the top plates clashing. The
hotcupboard top plate should then be wound down to its correct height once the appliance is in its
final position.
For induction top versions the top plate adjusters will need to be wound upwards before the
hotcupboard can be fitted onto its plinth, in order to provide adequate clearance between the
two top plates.
1.
Detach hotcupboard from plinth by removing two screws and tongue bracket from plinth (
Fig.
3.1
), slide hotcupboard forwards and away from rear fixing bracket (
Fig. 3.2
).
Fig. 3.1
DESN 517788
DESN 516449
Fig. 3.2
Summary of Contents for eR7 100-3
Page 3: ...ii ...
