27
12. Once the handrail assembly is located squarely, lock the handrail in position by winding in the grub screws on the
underside of each handrail bracket.
13. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be carefully pushed into place
until they sit flush with the outside face of each bracket (a light smear of lubricant such as, hand or dish soap on the
end cap ‘O’ rings may ease fitment.
14. Finally, fit the plinth facia to the magnets on the front of the plinth, making sure that on 5 oven appliances the right hand
side of the module plinth facia sits against the left hand side of the AGA Dual Control plinth facia leaving no gap
between. Make sure that the plinth facias are centrally located and do not overhang either appliance. (See Fig. 25)
Commission the AGA Dual Control, as stated in the relevant Installation Instructions and carry out functional test on each
of the features of the AGA Dual Control.
Fig. 26
WIRING DIAGRAM - AGA DC5G (HOTCUPBOARD OPTION)
CAUTION:
LABEL ALL WIRES PRIOR TO DISCONNECTION, WHEN SERVICING
CONTROLS WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION.
VERIFY PROPER OPERATION AFTER SERVICING
Summary of Contents for DC3G
