AGA DC3G, Installation Manual, Page: 12 / 36

12
POWER SUPPLY - HOTCUPBOARD (AGA DC5)
The hotcupboard attachment requires an independent single phase supply. It has a maximum load of 6 amps,
protected by an appropriate branch circuit supply.
110/120V FLEXIBLE CORD and PLUG PARALLEL TYPE (NEMA 5-15P). The appliance when installed must be electrically
grounded with local or state codes.
An electrical socket must be provided within 5 feet of the LH side of the appliance and easily accessible for the user to
disconnect. Do not position the socket above the appliance. See Fig. 6A, Page 14.
Take special care when cutting holes in wall or floor. Electrical wires may be behind the wall or floor covering and could
cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the installation of this product and disconnect power circuit.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a NEMA 5-15P grounded plug for your protection against a shock hazard and should be
plugged directly into a proper receptacle. Do not cut or remove the grounding prong from this plug.
Do not have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit could result in electrical
shock.
Do not use an extension cord with this appliance.
Check with a qualified electrician, if you are not sure the appliance is properly grounded.
Failure to follow these instructions could result in death or serious injury.