22
2. Position the plinth alongside the AGA Dual Control leaving no gap between the two plinths (See Fig. 16).
Check with a spirit level that the plinth level is correct, and also check height differential between the hotcupboard plinth
and Dual Control plinth is correct 3/8” (11mm). If necessary, use shims in each corner to level the plinth.
Fig. 16
DESN 516276
HOTCUPBOARD
PLINTH BASE
3/8” (11mm) HEIGHT
DIFFERENTIAL
3. Attach hotcupboard plinth to the AGA Dual Control plinth using M6 screws and washers provided (See Fig. 17).
Attach locking screw and jacking screw into plinth. Make sure at this stage that the jacking screw does not protrude
beyond outer face of plinth. Ensure locking screw is located into AGA DC3 plinth but not fully tightened. A gap of
approximately
1
/
8
” (3mm) should be present between the plinths apart from at the very front where the hotcupboard
spacer plate should be touching the AGA DC3 plinth.
Fig. 17
DESN 516550
+1
- 0
Summary of Contents for DC3G
