AGA marvel ML15WSF3 Series, Installation, Operation And Maintenance Instructions

Page: 16 / 93

OVERLAY DOOR PANEL
INSTALLATION
16
If you purchased an overlay panel model, your unit is
equipped with articulated hinges to allow fully integrated
built-in installations. Custom panel thicknesses of
5
⁄
8
" (15
mm) and
3
⁄
4
" (18 mm) are accommodated.
It is important to
use the factory
provided grille
that came with the product to assure proper air flow is
maintained through the condenser. The use of a custom
grille is not recommended and will void the warranty.
!
WARNING
Overlay panel models are designed for use with builtin
installations only . Use in freestanding installations
could result in personal injury.
Step 1: Removing the Door
With a phillips screwdriver remove the screw and "P" clamp
from the bottom of the door near the hinge. See Figure
13b.
Disconnect the door wire harness by pressing and holding
down the locking tab on the wire connector and pulling the
connector apart. See Figure 14.
Open the door and loosen the screws holding the hinges to
the cabinet (2 at the top and 2 at the bottom hinge). Do not
remove the screws but loosen them enough so the hinges
can be slipped off of the screws when sliding the door to
the side.
!
WARNING
The articulated hinges have many pinch points. Carefully
close / collapse the hinges as soon as the door is
removed from the cabinet.
With a helper, and being careful not to scratch the cabinet
or the door, slide the door to the side about
1
⁄
2
inch and
remove the hinges and door from the unit.
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 15. Set the gasket
aside on a flat surface.
!
CAUTION