AG SPRAY 5303225, Owner'S Manual

Page: 2 / 14

Page 2
Technical Specifications

65 or 105 Gallon Corrosion-Resistant Polyethylene
Tank

ProSeries 22” HP Long Range Ergonomic Handgun

25 Ft. Handgun Hose

27 Ft. Max. Vertical Throw, 38 Ft. Horizontal Throw

12 Volt, 5.3 GPM ShurFlo Pump

Molded-In Tank Baffle w/Sloped Floor

Molded-In Outlet Fitting for Complete Cleanout

3-Section Manual Control Swing Arm w/Position
Detents
The PROFESSIONAL SERIES is designed with many features to make operation more user friendly with years of
trouble free use.
Assembly Instructions
The sprayer is assembled already at the factory. The only assembly you will need to do is attaching optional boom or
hose reel when purchased.
Connect the electrical hook-up to the unit and connect the wires to a fully charged battery.
Read the operating instructions and then run the sprayer using only water for testing. When everything tests all right, add
the desired chemical mixture and water combination and start the spraying operation.
IMPORTANT: Remove tank lid and be sure the tank is clean and free of any foreign material. Rinse tank out of any tank
residue before filling with water to test.
Testing the Sprayer
NOTE:
It is VERY important for you to test your sprayer with plain water before actual spraying is attempted. This will enable
you to check the sprayer for leaks without the possibility of losing any expensive chemicals.
Fill the tank about 1/2 full with plain water and drive to the starting place for spraying.
When you are ready to spray, turn the pump on with the switch mounted in the control arm, then turn the boom valve to
the “on” position (if applicable). This will start solution spraying from the tips of the boom. The pressure will decrease
slightly when the boom is spraying.
Adjust the pressure by using the control valve mounted on the control arm. Make sure your pattern is sufficient. You may
down-pressure the system by ‘bypassing’ solution back into the tank. This is achieved by opening the bypass/control
valve. Regulating pressure is done in this manner.
Read the operating instructions and initially begin spraying by closing the bypass valve and opening the boom line valve.
This will enable the air in the line to be eliminated (purged) through all the tips, while building pressure. When everything
tests all right (no leaks and good pressure), add the desired chemicals to the mixture and water combination and start
your spraying operation. Adjust the pressure and spray as you did in the testing procedure.
Conditions of weather and terrain must be considered when setting the sprayer. Do not spray on windy days. Protective
clothing must be worn in some cases.
Be sure to read the chemical label(s) before application!
OPTIONS

50’ Manual Hose Reel w/180° Swivel

Booms: Traditional 13’ to 28’ or Boomless 40’
Coverage