AG SPRAY 5281784, Owner'S Manual

Page: 10 / 34

Page 10
Pre-Start Instructions
A. Fill the tank full if using water only, half full, if you are to add chemicals.
B. Check that the PTO shaft and attached pump shaft turns freely by hand (DO NOT attach PTO shaft or operate the
pump, if the pump does not turn freely by hand, because it may be locked up and may cause serious injury).
C. Attach PTO shaft, making sure the lock pin is locked on the PTO shaft.
D. Check that all shields are in place.
E. Check that there is oil showing in the sight glass of the pump. Add oil, if needed.
F. Clean and inspect strainer screen.
G. Check all hoses and fittings for tightness, wear and leakage.
H. Set the following valve lineup:
1) Pump suction valve OPEN.
2) Pressure control valve - pressure adjusting handle in the UP position.
3) Hose reel ball valve CLOSED.
4) Rear boom ball valve OPEN.
5) All individual nozzle isolation valves set to achieve desired pattern.
I. Check the oil, water and fuel on the tractor.
J. Check lug nus and check tire pressure (40 PSI cold inflation).