5
O
N
T
RAC
3
MDU-G4
• If an abnormal phenomenon presents itself, for example excessive vibrations noise, then immediately turn
off the OnTrac3 GPS Assisted Steering System and consult a responsible expert.
• When the OnTrac3 GPS Assisted Steering System is being cleaned or when maintenance takes place, it
must be totally turned off and free of any electrical currents.
• The operator of the OnTrac3 GPS Assisted Steering System must have complete knowledge about how
to react in case of emergency.
• A trained expert must always carry out maintenance or repairs on the OnTrac3 GPS Assisted Steering
System.
• During repair or replacement of components on the OnTrac3 GPS Assisted Steering System only original
components must be used.
• Always wear correct prescribed personal protection equipment during the use or cleaning or maintenance
of the OnTrac3 GPS Assisted Steering System.
• Always use the recommended cleaning materials and accessories when the OnTrac3 GPS Assisted
Steering System is cleaned.
• Every unsafe condition or situation on the OnTrac3 GPS Assisted Steering System must be reported to
the responsible persons.
• Do not leave or place objects on or in the area of the OnTrac3 GPS Assisted Steering System.
W
ARNING
A
LERTS
The OnTrac3 system installer and manufacturer disclaim any responsibility for damage or physical harm
caused by the failure to adhere to the following safety requirements:
• As the operator of the vehicle, you are responsible for its safe operation.
• The steering system is not designed to replace the vehicle’s operator.
Note:
After the installation of the OnTrac3 system, verify that all the screws, bolts, nuts, and cable
connections are tight. Verify that all the cables have been secured to prevent them from being
damaged.
WARNING:
To understand the potential hazards associated with the operation of a OnTrac3
equipped vehicle, read the provided documentation prior to installing or operating the OnTrac3
system.
WARNING:
To prevent accidental death or injury from being run over by the vehicle or automated
motion of the steering system, never leave the vehicle’s operator seat with the OnTrac3 system
engaged.
WARNING:
Movement of the Electronic Control Unit (ECU) relative to the vehicle may cause erratic
steering and sudden loss of vehicle control while in AutoSteer mode. Always keep the ECU firmly
secured to the vehicle. Do not operate your OnTrac3 system with a loose ECU.
WARNING:
To prevent accidental death or injury from being run over by the vehicle verify that area
around the vehicle is clear of people and obstacles before startup, calibration, tuning, or use of the
OnTrac3 system.