©Copyright Lotronic 2018
3
PIXSTRIP40
•
Power & signal transmission via RJ45 (lead included)
•
Mechanical link system between two bars
Product Description
1.
Fastening knob
2.
RJ45 in/out
3.
Hanging/mounting bracket
4.
Bracket angle adjustment knob
5.
RJ45 in/out
6.
Safety loop
7.
Bracket position adjustment knobs (used to align
end-to-end on truss)
Installation
Unpack all parts carefully and put them on a stable surface.
Connect the unit via a standard RJ45 cable to the output of the strip controller.
Installation of Clear/Frost filter
The unit contains a pre-installed frost filter. Follow the steps below to install the included clear filter.
Remove the 4 screws from the end cap that is not fitted with connectors.
Slide out the installed filter and insert the desired filter.
Put the end cap back in place and secure it with the 4 screws.
Please note: Install the frost filter with the shiny side facing towards the LEDs.
Mounting
The unit comes with an adjustable mounting bracket and a safety loop. The mounting bracket has
three 13mm holes to attach a clamp directly to the mounting bracket and serves as support for either
mounting on the floor or on the wall. The safety loop is used to attach a safety cable.
Mounting Guidelines
1.
Before deciding on a location, make sure that the product remains easily accessible for
maintenance and repair.
2.
Make sure that the mounting structure or surface can support the weight of the product.
3.
When mounting the product overhead, always use a safety cable. Mount the product securely to
a rigging point, such as an elevated platform or a truss.
