30 Operation
Go to the HMI screen and press “
MANUAL
” tab, press the “
FILM”
button.
Film will self-align on the mandrel. Drive film down past cutting point of Mandrel. Run
the film until it is not “wrinkled”.
Press “
CUT
”, The film is cut. Check to see if it is cutting between cutting point of Mandrel.
If Cutter is performing correctly, re-tighten the set screws for both sets of wheels.
The Film Feed Roller adjustment is located on the front right-hand side inside the door of
the LX-100. The illustration shows the area of location. The wheels of the Film Feed
“Spitter” are vertically adjustable, and can be loosened or tightened on the Mandrel using
the Tightening Adjustment wheel. Horizontal movement is pre-set, and is not adjustable.
If wheels are too loose or too tight, there may be “burnout” marks left on the film and
rollers. Ensure that adjustments are done accordingly.
NEXT
SETTING
MANUAL
WORK
1934
CYCLE
CUT
FILM
MANUAL
1944
X
2098
Applicator
Wheels
Z Adjust
Location
of Film
Feed
Spitter in
machine
Vertical
adjustment
Summary of Contents for LX-100
