14 Installation and Setup
Mounting
After unpacking the Bracket Assembly, assemble it per the illustration, if required.
Find a spot to mount to Conveyor approximately 1” down from top of Conveyor.
Measure the distance to the Sleever (if used), and drill though one side of Conveyor.
Mount the Bracket to the Conveyor using the enclosed ¼-20 hex bolts. Tighten bolts and
nuts until snug. Fender washers may be used.
2208
Mount this angle to
Conveyor
approximately. 1”
lower than top of
Conveyor,
depending on
container size
Mounting
slots
2209
Summary of Contents for GS 100
