Afikim afiscooter-s, Service Manual

Page: 27 / 37

Service Manual AFISCOOTER S v.1.9
Ver. 01
27
12.5
Controller Trip codes using programmer SP1 & actions to repair:
When the fault exists, connect the SP1 programmer's connector directly to the controller
SDRIVE140 or to the charging socket, using a special wiring adaptor.
Trip
Code
Action
A01
Quick switch ON / OFF. Switch OFF wait few seconds and ON again.
Possible fault of main key-switch. If hundreds time suspect the keyswitch.
0300 Check the tiller & throttle wiring to the controller, then retest
0815 Check the tiller & throttle wiring to the controller, then retest
0A00 Check the sleep mode parameter is set correctly, then retest
0E07 Check the tiller & throttle wiring to the controller, then retest
0E08 Check the tiller & throttle wiring to the controller, then retest
1501
Check the solenoid brake’s wiring & connections to the controller, then retest
1502
Check the solenoid brake’s wiring & connections to the controller, then retest
1600
Check the batteries’ wiring & connections to the controller, then retest
Possible high voltage due to high load downhill. Possible to decrease the half speed parameter
to 40% and instruct the user to drive 1/2 speed mode down-hills.
1601
Check the batteries’ wiring & connections to the controller, then retest
1705 Internal faults in relay.
1E08 Check the wiring & connections to pin 4 of the programming socket, then retest
1E09 Check the wiring & connections to pin 6 of the 14 way tiller connector, then retest
1E0A Check the wiring & connections to pin 14 of the 14 way tiller connector, then retest
2C00
Check the batteries’ wiring & connections to the controller, then retest
2F01 Check the throttle is not displaced on start-up, then retest
2F01 Check the tiller & throttle wiring to the controller, then retest
3100 Battery connected whilst scooter is switched on. Turn off, wait 10 seconds, then retest