3
Note: Before you begin, use “Painters Tape” to apply a protective guard around the work
areas (fender and bumper valance). This will help protect the paint and finish of your vehicle.
1.
Disconnect the negative battery terminal.
2.
Locate ten (10) plastic clips on top of plastic shroud and one (1) additional on each side
located at the top of the headlight body panel cover. Carefully pry off to remove and then
set aside for reinstallation later.
3.
Remove plastic shroud and then set aside for reinstallation later.
Summary of Contents for Scorpion 79-21002L
