![background image](http://html.mh-extra.com/html/afe-power/scorpion-79-21002l/scorpion-79-21002l_instruction-manual_2864094038.webp)
37
PLEASE CONSULT YOUR LOCAL AUTOMOTIVE ELECTRICAL PROFESSIONAL FOR INSTALLATION SERVICES AND
ADVICE. aFe Power IS ONLY EQUIPPED TO PROVIDE BASIC TECHNICAL ASSISTANCE DUE TO THE DIVERSITY OF
VEHICLES, VEHICLE OPTIONS & MODIFICATIONS AND LIGHTING.
CONFIGURATION OPTIONS AVAILABLE. aFe Power products cannot be held liable due to improper component
installation and / or faulty wiring.
GENERAL GUIDELINES:
LED Lights & LED Light Bars operate at relatively high currents and should only be installed by qualified personnel
with experience in switched / relayed high draw DC Circuits.
- Light Bars are designed for use only with standard 12v DC power systems
- Light Bars are for OFF-ROAD USE ONLY. Check your local laws & regulations regarding vehicle mounted lights.
- Some Light Bars are equipped with waterproof connectors while others are simply pig-tailed
- Red Wires = POSITIVE | Black Wires = NEGATIVE
-
ALWAYS install your lights on a fused circuit. Basic fusing guidelines: maximum 5A for every 10” of LED Light Bar.
GENERAL USE, INSTALL AND ADJUSMENT TIPS
NOTE 1: aFe Scorpion Grilles (with LED Light Bars installed), and LED Light Bars themselves are for OFF-ROAD USE
ONLY.
NOTE 2: To adjust the angle of your light bars simply loosen the mounting hardware on either side of each Light
Bar, rotate the Light Bar to adjust the angle, then tighten the hardware once the desired angle is achieved (please
be careful not to over-tighten the mounting hardware or scratch the protective powder-coat finish). It is best to
adjust the angle with the vehicle on level ground with the lights facing a wall, garage door or other solid barrier at
approximately 25-30 feet.
NOTE 3: Please consult a qualified automotive electrical professional for light bar wiring installation.
Summary of Contents for Scorpion 79-21002L
