Afag UG 20 NC, Montage & Maintenance Instructions

Page: 13 / 36

UG 20-UG 25-OI-vers. 3.5 gb. 20190409 13
3.1.4 Scope of supply
Quantity Description
1 Module
2 Centering bushings Ø 5x2.5 mm (UG 20)
2
2
4
2 Centering bushings Ø 7x3 mm (UG 25)
Mounting screw M3x30 mm (UG 20)
Mounting screw M3x50 mm (UG 20)
Mounting screw M4x35 mm (UG 25)
4 Mounting screw M4x55 mm (UG 25)
Intended use
The series of the UG Universal gripper is used for the linear movement of rigidly
mounted loads under the ambient and Installation conditions defined for this module;
see Technical catalogue.
NOTE
These Montage Instructions should be read carefully before carrying
out any activity on or with the module.
The module may only be deployed in accordance with the intended
use.
Modifications on the module that are not described in these Montage
Instructions or have not been approved in writing by Afag are not
permitted. In case of improper changes or assembly, installation,
operation, maintenance or repairs, Afag rejects all liability.
CAUTION
Connection of compressed air and operation of pneumatic
systems may cause unpredictable movements which may result
in personal injury or damage to property.
When connecting compressed air for the first time make sure that all air throttles are
closed. Aerate the system slowly.