P a g e
|
25
Receiving A Call and Opening Gates / Door
Visitors can press the call button, which will initiate a call from your intercom to the designated
phone numbers which will have been programmed by your installer.
1.Visitor
presses the call
button or waves
in front of
sensor.
2. Intercom
flashes and
captures image.
3. Intercom
sends image to
phone and waits
10 seconds.
4. Intercom calls
up to 4 phones
in sequence
5. Answer the
call, speak to
visitor, and grant
access with
phone keypad.
Access Control by Calling the intercom
(CallerID)
Output 1
Output 2
All residents can call the intercom to gain access at no call charge
using CallerID.
To open, simply ensure you have the phone number programmed
for CallerID and then call the intercom phone number from the
stored number and the relay will trigger as per programmed.
This is usually main gate/door.
Press 1# to open
Press 2# to hold open
Press 3# to un-hold
This can be pedestrian gate,
driveway lights or other.
Press 4# to open/activate
Press 5# to hold open/turn on
Press 6# to un-hold/turn off
Output 1
Output 2
DISABLE DTMF Confirmation
Remove the ‘#’ confirmation. Press 1, 2, 3
to trigger, latch & unlatch.
(
False triggering may occur when disabled
)
9999
#
52
X
#
(X=1 enable; X=0 disable)
ENABLE Latching feature via DTMF.
If latching is required.
9999
#
95
X
#
(X=1 enable; X=-0 disable)
Tip:
We recommend naming your intercom in your
phonebook so you can call it by voice command.
1
1
Intercom
Call from
Intercom
Intercom
1
2
3
4
5
6
7
8
9
*
0
#
Keypad
Mute
Bluetooth
Summary of Contents for KEY-AUX-PBPK-US
