P a g e
|
19
Exit Button (PTE)
When the exit button is pressed it will trigger relay 1 for the pre-programmed time in the app. (Default is 1 second)
Status LEDs
CPU
Flashing = standby
Constant ON/OFF = busy
SIGNAL STRENGTH
1 flash = poor (1 bar)
2 flashes = low (2 bars)
3 flashes = good (3 bars)
4 flashes = strong (4 bars)
5 flashes = searching
POWER
MODEM
Flashing = standby
Constant ON/OFF = searching
Do NOT use fine gauge cable such as CAT5, CAT6, Alarm Cable
etc to power this device as damage will occur.
0-2 metres (6 feet)
– min 0.50mm
2
(18 gauge)
2-4 metres (12 feet)
– min 0.75mm
2
(16 gauge)
4-8 metres (24 feet)
– min 1.0mm
2
(14 gauge)
Summary of Contents for KEY-AUX-PBPK-US
