11
REMOVING THE ACTIVEPURE
®
CELLS
CAUTION
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light, can cause eye
damage according to the American Conference of Governmental Industrial Hygienists (ACGIH) Standards.
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Aerus
®
Pure & Clean without the Filter Assembly and Back Cover properly installed
NOTE:
Use genuine Aerus replacement parts only. Parts from anyone other than Aerus may damage your unit and void your warranty.
1.
Unlock the ActivePure Cell
connector by pressing on
the connector’s locking
tabs.
2. Pull the connector
straight out to unplug.
3. Remove two (2)
thumbscrews.
4. Slide the ActivePure
Cell down and out of
the unit.
INSTALLING THE ACTIVEPURE
®
CELLS
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Aerus Pure & Clean without the Filter Assembly and Back Cover properly installed
1.
Slide the ActivePure Cell up and into
the unit. Be sure the back lip of the
ActivePure Cell engages the two
slotted protrusions at the rear of the
unit, and that the angle brackets and
studs are correctly aligned.
3. Press the connector firmly until the
two tabs lock into place.
5. Use the included screwdriver to
screw in the Filter Assembly.
6. Replace the Back Cover by
inserting the bottom in first
and snapping it into place.
2. Insert the two thumbscrews and
tighten. Insert the ActivePure Cell
connector into the plug at the rear
of the unit.
4. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first.
