12
The Air Scrubber Mobile by Aerus
®
unit must be turned off and disconnected from power
before servicing, and should not be powered back on until the case is correctly and completely
reassembled.
CAUTION
INSTALLING THE ACTIVEPURE
®
BULB ASSEMBLY
3-PIN CONNECTOR
CIRCUIT
BOARD
a
b
c
d
TABS
ACTIVEPURE
TARGET FRAMES
C
C
C
C
A
B
D
E
A. WIRE STAND
9950153
B. BASE
9950154
C. KNOB/CLAMP PACK (2)
9950155
D. 12VDC ADAPTER
9950157
E. 2.0 AMP FUSE
9950162
F. AC ADAPTER
9950158
Fuse for 12VDC Adapter only
LO
CK
OP
EN
LO
CK
O
PE
N
PUSH
F
UV BULB
ACTIVEPURE TARGET
Reinstallation is the reverse of the steps illustrated on page 7.
1.
UV Lamp —
Do not touch with bare hands. If touched,
clean the bulb with a cotton swab and a small amount
of isopropyl alcohol.
2. Attach the 3-pin connector of the ActivePure Bulb
Assembly to the main unit circuit board.
3. Carefully align the two holes in the ActivePure Bulb
Assembly to the two tabs on the main unit.
4. Press gently to install the ActivePure Bulb Assembly.
5. Carefully replace the bottom case, being sure the pins
inside the the back of the bottom case fit into the two
standoffs at the back of the top case.
6. Slide the bottom case forward then down, making sure
the wires are completely inside the case.
7. Check for proper alignment the before installing and
tightening the screws.
NOTE:
Failure to correctly assemble may cause damage
to the case.
8. Replace cover and two screws.
