R
SETTING BETWEEN TRANSMITTER AND RECEIVER
DELETING SAVED PROGRAMMES
1 - disconnect the power line of the QB wall mounted
2 - unscrew the aerial and open the receiver
(R)
, remove the electronic card
(S)
and press the button
(H)
.
3 - while still pressing the button
(H)
, reconnect the power to the unit.
4 - the LED
(K)
will switch on.
RECEIVER
ELECTRONIC CARD
H
K
S
THE SETTING BETWEEN TRANSMITTER AND THE RECEIVER IS ALREADY SET BY THE MANUFACTURE
A
TRANSMITTER INSTALLATION WITH ROBÒ SELF CLEANING BASE
1 - removing battery
(C)
inside transmitter
(T)
2 - put the transmitter
inside the lodging
(G)
3 - inserting support
(D)
and lock the transmitter .
4 - fix support
(D)
at the base through the screw
(H)
.
Transmitter
(T)
turns on and off the central vacuum unit
when ROBÒ positions itself on self-cleaning base to start
the emptying phase of its dust container.
T
G
C
Lithium battery 3V (CR2032)
Via Cerchia di S. Egidio, 760
47521 Cesena (FC) Italy
AERTECNICA S.P.A.
Tel. +39 0547 637311
Fax +39 0547 631388
www.aertecnica.com
5 - release the button
(H)
.
6 - when the LED
(K)
switches off, the receiver memory has been deleted.
Once the memory of the receiver
(R)
has been deleted, reprogram the
transmitter
(T)
following previous procedure.
H
T
D
QB POWER CONNECTION WITH RECEIVER
2
- Insert a junction box
(Q)
and wire the connection cables between the
QB unit and the Wireless Receiver
(R)
.
1
- Fit the Wireless Receiver
(R)
on the wall at a minimum distance of
150 cm from the QB unit.
Activation Line 12V for vacuum sockets
brown cable
(+)
grey cable
(S)
black cable
(-)
WIRELESS RECEIVER POWER SUPPLY
The power supply of the receiver
(R)
is 12 volts
There is no electricity hazard.
distance ≥ 150 cm
R
Q
BROWN
(optional)
GREY
BLACK
SOCKET LINE 12V
PROCEDURE
1
- check that the connection between the receiver
(R)
and the central
vacuum unit is correct.
2
- unscrew the aerial and open the receiver
(R)
3
- remove the electronic card
(S).
4
- press the button
(H)
, the LED will switch on
(K)
.
The central vacuum unit and the wireless receiver must remain connected to the power supply
The wireless receiver is powered by 12 volts so no electrical hazard risk exists.
5
- press the start button
(A)
of the transmitter
(T)
within 5 seconds
6 -
wait a few seconds for the memorisation of the new signal
7 -
close the receiver
(R)
and rescrew the aerial.
The setting has been completed. Whenever the transmitter button
(A)
is
pressed, the central vacuum unit will switch on.
