Aerservice Components RECAR227, Installation And Use Manual

Page: 26 / 32

Tel. +39 049 641 679 | commerciale@aercomponents.it | www.aercomponents.it
26
Logic of coding
Left-Right / EA / OA / SA / RA
There is a spigot on top view (1)/not (0).
There is a spigot on top view(1)/not (0).
There is a spigot on top view(1)/not (0).
There is a spigot on top view(1)/not (0).
Unit is left hand or right hand.
0
= not
1 = exist
EA = Exhaust Air
SA = Supply Air
OA
= Outdoor Air
RA
= Return Air
SA
EA
OA
RA
DISCHARGE CONDENSATE INSTALLATION
Moisture condensed water should be drained out of the unit, to prevent water damage in heat
recovery unit and ductwork system.
Following precautions should be observed :
1. Condensate pipe connections to main drainage line should not be less than the diameter of
the drainage outlet connection (Not less then a diameter of 20 mm).
2. A union or pipe coupling should be fitted at the pipe connections to permit easy disconnection
to clean any dirt sediments.
3. The connection drain pipe shall have a diameter of at least 20 mm and a sufficient slope;
under no circumstance may the drain pipe be connected directly.
INSTALLATION
Codifica
Sn-Ds / EA / OA / SA / RA
Si può notare un raccordo sulla parte superiore (1)/(0).
Si può notare un raccordo sulla parte superiore (1)/(0).
Si può notare un raccordo sulla parte superiore (1)/(0).
Si può notare un raccordo sulla parte superiore (1)/(0).
Sezione sinistra o destra
0 = assente
1 = presente
EA
= Espulsione
SA
= Mandata
OA = Aria Esterna
RA = Ripresa
SA
EA
OA
RA
min. 110 mm
Clearance for condensate drain
EN