10
240 VAC MODE
When used WITH the ADAPTER, the charger can charge in Level 2, 240 VAC
mode.
1.
Snap the ADAPTER CLIP
to the lower end of the CHARGE MODULE,
lining up the appropriate symbols ( and ) on the clip and module.
2.
Insert the CHARGE MODULE into the ADAPTER
(make sure it is fully
inserted or the clip will not slide into the lock position).
3.
Slide the ADAPTER CLIP
up to the top of the CHARGE MODULE to lock
in place.
4.
Insert the CHARGE MODULE
with the attached ADAPTER into the
appropriate 240 VAC wall outlet.
5. The BLUE STATUS Indicator on the CHARGE MODULE should be ON. This
means that the charger is ready to provide power to your vehicle.
6.
Plug
the CHARGE COUPLER into your vehicle’s charging receptacle until it
clicks. Once latched, the CHARGE COUPLER will not disengage unless the
release button is pressed manually.
7.
Automatic charge begins
. Power will be delivered in accordance to
vehicle demand. If the vehicle is charging, the BLUE STATUS Indicator will
blink on and off approximately every two seconds. Always verify that the
vehicle charging status indicator agrees.
8.
When fully charged
, the BLUE STATUS Indicator light illuminates solid
blue. Your vehicle has a “dashboard gauge” which can verify that the
vehicle is fully charged. Refer to the vehicle owner’s manual to find the
gauge location on your dashboard.
9.
Disconnect
when the charge is complete by pressing the release button
on the CHARGE COUPLER and removing it from the vehicle.
←
←
←
1
3
2
Charge Module
Adapter Clip
Adapter
Summary of Contents for TurboCord
