Aerotech BA10 SERIES, User Manual

Page: 9 / 62

BA10/20/30 Series User’s Manual Regulatory Information
Version 1.6
Aerotech, Inc.
ix
DECLARATION OF CONFORMITY
Manufacturer’s Name and Address
Aerotech, Inc.
101 Zeta Drive
Pittsburgh, PA 15238-2897
Declares that the product:
Product Name: Brushless Servo Amplifier (BA Series)
Conforms to the following product specifications:
EMC: EN 55011: 1991 Class B Emissions
EN 50082-1: 1992 Immunity
IEC 801-2: 1984
IEC 801-3: 1984
IEC 801-4: 1988
LVD: IEC 204-1
and complies with EMC directive 89/336/EEC.
Pittsburgh, PA
David F. Kincel_________________________
February, 1998 Quality Assurance Manager
Robert
Novotnak__________________________
Engineer Verifying Compliance
General notes concerning the test setup.
This product was tested at Washington Laboratories, LTD. in Gaithersburgh, MD on
October 19, 1995. The report number is WLL 2956F.
The brushless amplifier was tested with a brushless servomotor. To ensure that the
product passes the conducted emissions tests, a line filter and common mode choke must
be connected to the main inputs. The filter is a Schaffner FN 2070-10-06 and the common
mode choke is a Renco Electronics RL-1329-1200. Ferrite must be added to each line of
the main inputs but not earth ground. In order for the product to conform to the radiated
emission standards, the motor cable must be shielded and the shield must be tied to the
earth ground. Ferrite must also be added (in common mode) to the motor cable but not
around the shield. Finally, a metal 25-pin connector with a metal backshell must be used
when making a connection to the 25-pin receptacle on the amplifier. The shield of the
feedback cable must be tied to the metal backshell. Failure to follow the described
procedures may cause the amplifier/motor to exceed emission limits.
∇ ∇ ∇