10
Figure 20
13. Remove the auxiliary bungee from the
shackle and the hook.
Take the sweep (crosstube tensioning) wires
shackle with one hand and check that the
sweep wires are not twisted. At the same
time with another hand pull the crossbar
backwards – this will considerably help
attaching the shackle of the sweep wires to
the hook, placed on the keel tube (Fig. 20).
14. Install the tip battens and fix all the
battens with the double tensioned ropes
and rubber bands.
15. The next step is to install the outboard sprogs. Swing the sprog away from the leading edge
and push it towards the leading edge in to the receptacle. Make sure the sprog sits all the way
in the sprog receptacle (Fig. 21).
Figure 21
Figure 22
16. Install the inboard sprogs. Swing the sprog away from the leading edge and fix it with
buckles as shown on the figure 22.
17. Fix the side strut back-up wire with bolts and nuts and secure with safety rings as shown on
the figures 23 and 24.
Figure 23
Figure 24
