6
Framing Nailer ACHF9034 www.aeroprotools.com
Before starting work,make sure that the switching device is properly set.
If the switching device is not set properly, the nailer will not operate correctly.
Never place your hands or feet closer than 8 inches (200 mm) from firing head when using.
Do not drive nails on the top of other nails or with Nailer at too steep of an angle; nails can ricochet and hurt someone.
Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from
workpiece and hit someone.
Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a
person on the opposite side.
Never use Nailer which is defective or operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when:
1) it is not in use; 2)leaving work area; 3)moving it to another location; 4)handing it to another person; and
5) changing switching device.
This nailer is equipped with a nailer operation switching device.
Use SINGLE SEQUENTIAL ACTUATION MECHANISM or CONTACT ACTUATION MECHANISM in accordance with the
work to be performed.
Explanation of the various nailing operations:
SINGLE SEQUENTIAL ACTUATION MECHANISM: First, press the push lever against the workpiece; next, pull the
trigger to drive the nail. After nailing once,nailing will not be possible again until the trigger is released and pressed
again.
CONTACT ACTUATION MECHANISM: First, press the push lever against the workpiece; next, pull the trigger to drive
the nail. Or, pull the trigger; next, press the push lever against the workpiece to drive the nail. If the trigger is held
back, a nail will be driven each time the push lever is pressed against the workpiece.
METHODS OF OPERATION
This Nailer is equipped with the push lever and does not operate unless the push lever is depressed (upward
position).There are two methods of operation to drive nails with this Nailer. They are:
1. Intermittent operation (Trigger tire);
2. Continuous operation(Push lever fire).Intermittent operation(Trigger fire) use the SINGLE SEQUENTIAL ACTUATION
MECHANISM setting.
For intermittent operation, set the switching device to the upward position completely (i.e.Set to SINGLE SEQUENTIAL
ACTUATION MECHANISM.)
To avoid double firing or accidental firing due to recoil.
1)Set the switching device to SINGLESEQUENTIAL ACTUATION MECHANISM.
2)Pull the trigger rapidly and firmly.
①
Set the switching device to the upward position (to set to SINGLE SEQUENTIAL ACTUATION MECHANISM).
