9
Framing Nailer ACHF9034 www.aeroprotools.com
transportation. Connect the fastener driving tool to the compressed air supply using suitable pressure hose equipped
with quick-action connectors. Check for proper functioning by applying the muzzle of the fastener driving tool to a piece
of wood or wooden material and actuating the trigger once or twice.
4.3Filling the magazine
Only those fasteners specified under TECHNICAL DATA (see 1.1) may be used
When filling the magazine, hold the tool so that the muzzle is not pointing towards the operator or any other person or animals.
4.4 Handling the tool
Pay attention to
2-Special Reference-
of these operating instructions.
Having checked that the fastener driving tool is functioning correctly, apply the tool to a work piece and actuate the trigger.
Check whether the fastener has been driven into the work piece in accordance with the requirements.
- if the fastener is protruding, increase the air pressure in increments of 0.6 bar, checking the result after each new adjustment;
- if the fastener is driven into an excessive depth reduce the air pressure I increments of 0.6 bar until the result is satisfactory.
You should endeavor in any event to work with the lowest possible air pressure. This will give you three significant advantages;
1.energy will be saved, 2.less noise will be produced, 3.a reduction in fastener driving tool wear will be achieved.
Avoid triggering the fastener driving tool if the magazine is empty.
Any defective or improperly functioning fastener driving tool must immediately be disconnected from the compressed air
supply and passed to a specialist for inspection.
In the event of longer breaks in work or at the end of the working shift, disconnect the tool from the compressed air supply
and it is recommended to empty the magazine.
The compressed air connectors of the fastener driving tool and the hoses should be protected against contamination, the
ingress of coarse dust chips, sand etc, will result in leaks and damage to the fastener driving tool and the couplings.
DANGER!
Potential hazard that could result in serious injury or loss of life
Disconnect the tool from the compressed air source before loading fasteners.
Do not point the tool towards the operator or other people while changing fasteners.
Do not hold the tool with the trigger depressed while changing the fasteners. Failure to comply will lead to serious
injury or loss of life.
WARNING! Potential hazard that could result in serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or damage to equipment.
Operate the tool with the utmost care when connected with the air compressor.
Failure to comply may result in moderate injury or damage to equipment.
Clearing a jammed fastener
Disconnect the tool from the air supply line.
Remove the fasteners that are stored in the tool
’s magazine.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Disconnect the magazine from the tool and remove the non-jammed fasteners from the tool before clearing
a jammed fastener. The fasteners are under pressure and failure to comply will cause them to be fired out of
the tool causing serious injury.
Do not point the tool towards the operator or other people. Serious personal injury could result if these
instructions are not followed.
Use pliers or any appropriate tool to remove the jammed fastener.
Reload the fasteners into the tool magazine.
Reconnect the air line to the tool's air inlet
Test fire 3 to 5 fasteners into a piece of scrap wood in order to ensure proper operation
