Aerohive BR200-WP, Hardware Reference Manual

Page: 107 / 124

Hardware Reference Guide 105
P
RODUCT
O
VERVIEW
Ethernet and Console Ports
The two 10/100/1000-Mbps Ethernet ports on the HiveManager labeled MGT and LAN use standard RJ45
connector pin assignments that follow the TIA/EIA-568-B standard (see Figure 3 on page 111 ). They accept
standard cat3, cat5, cat5e, or cat6 Ethernet cable. Because the ports have autosensing capabilities, the
wiring termination in the Ethernet cables can be either straight-through or crossover.
The pin assignments in the male DB9 Console port follow the EIA (Electronic Industries Alliance) RS-232
standard. To make a serial connection between your management system and the Console port on the
HiveManager, you can use a null modem serial cable, use another serial cable that complies with the RS-232
standard, or refer to the pin-to-signal mapping shown in "DB9 Console Port Pin Assignments" on page 114 to
make your own serial cable. Connect one end of the cable to the Console port on the HiveManager and
the other end to the serial (or COM) port on your management system. The management system must have
a VT100 terminal emulation program, such as Tera Term Pro
©
(a free terminal emulator) or Hilgraeve
Hyperterminal
®
(provided with Windows
®
operating systems).
The serial connection settings are as follows:
•
Bits per second: 9600
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
Status LEDs
The two status LEDs on the front of the HiveManager indicate various states of activity through color (dark,
green, amber) and illumination patterns (steady glow or blinking). The meanings of the various color and
illumination patterns for each LED are shown in Figure 2 .
Figure 2 Status LEDs
AC power inlet The three-prong AC power inlet is a C14 chassis plug through which you can
connect a HiveManager to a 100 – 240-volt AC power source using the
10-amp/125-volt IEC power cord that ships with the product.
On/Off switch The on ( | ) and off (

) switch controls the power to the HiveManager.
Power fan The fan that maintains the temperature of the power supply.
The default IP address/netmask for the MGT interface is 192.168.2.10/24. For the LAN interface, the
default IP address/netmask is 192.168.3.10/24. The IP address of the default gateway is 192.168.2.1.
Table 1 HiveManager component descriptions (Continued)
Component Description
System power
Dark: no power
Steady illumination: Powered
Hard disk drive
Dark: Idle
Blinking: Active