Aerohive BR200-WP, Hardware Reference Manual

Page: 72 / 124

Chapter 6 AP330 and AP350 Platforms
70 Aerohive
Locking the AP330 and AP350
To lock the AP to the rail mount or mounting plate, use either a Kensington lock or the security screw that is
included with the mounting kit. To use a Kensington lock, loop the cable attached to the lock around a
secure object, insert the T-bar component of the lock into the device lock slot on the AP, and then turn the
key to engage the lock mechanism.
To lock the AP to the rail mount or mounting plate or to lock the USB port cover, you can use either the
slotted screw or the security screw, both of which are included in the mounting kit. If you use the security
screw, you will need a drilled spanner insert bit for size #6 security screws and a screw driver that will accept
the bit. The correct bits are available from Aerohive in sets of three (AH-ACC-SEC-BIT-330-AP350-3PK). If you
use the slotted screw, you can install it with a standard flat-blade screwdriver or driver bit.
1. If you want to hide the USB port, attach the USB port cover by pushing the tab on the cover into the port.
2. Insert the security screw through the hole in the cover and the hole in the chassis. Using a screwdriver
with a drilled spanner bit, fasten the screw to the security tab extension on the rail mount, as shown in
Figure 7 , for the AP330. (If you want to expose the USB port, use the security screw without the cover.)
Figure 7 Locking the AP330 to the mounting plate
3. With the insert bit in a screwdriver, tighten the screw into place to secure the device to the plate.
Turn clockwise to tighten
USB port
USB port cover
Security screw
Device lock slot
Rail mount or
mounting plate
Screwdriver
Security tab
extension