ConnexLink User’s Manual
ConnexLink User’s Manual
ConnexLink User’s Manual
ConnexLink User’s Manual
7/11/2003
16
Status Reply Example
Status Reply Example
Status Reply Example
Status Reply Example
Name
Name
Name
Name
Type
Type
Type
Type
0 Active ConnexLinks
0 Active ConnexLinks
0 Active ConnexLinks
0 Active ConnexLinks
2 Active ConnexLinks
2 Active ConnexLinks
2 Active ConnexLinks
2 Active ConnexLinks
ConnexLink Time
Time Counter
1 Byte – TL
1 Byte – TM
1 Byte – TH
1 Byte – TL
1 Byte – TM
1 Byte – TH
Tx Failures
Error Counter
4 Bytes
4 Bytes
Tx Retries
Error Counter
4 Bytes
4 Bytes
Rx Failures
Error Counter
4 Bytes
4 Bytes
Rx Retries
Error Counter
4 Bytes
4 Bytes
Num Active ConnexLinks
Data Counter
0
2
List of Registered
ConnexLinks
Identity
6 Bytes IEEE Address
3 Bytes time stamp
3 Bytes packet count
6 Bytes IEEE Address
3 Bytes time stamp
3 Bytes packet count
Checksum
Actual
Actual
Data Frame:
8Bh
Length Low
00h
Data
Checksum
2.1.7
2.1.7
2.1.7
2.1.7
Update EEPROM Checksum
Update EEPROM Checksum
Update EEPROM Checksum
Update EEPROM Checksum
The Host issues this command to a ConnexLink to recalculate the checksum. The Host typically
issues this command after it has completed writing data to the EEPROM. The Host must wait for
the
Acknowledge
Acknowledge
Acknowledge
Acknowledge
command before issuing any additional commands.
Example: 8C|00|00|8C (There are no Data bytes for this command)
Acknowledge: 8C|00|00|8C
2.1.8
2.1.8
2.1.8
2.1.8
Check EEPROM Checksum
Check EEPROM Checksum
Check EEPROM Checksum
Check EEPROM Checksum
The Host issues this command to a ConnexLink to validate the EEPROM checksum. The Host
typically issues this command after resetting a ConnexLink. A ConnexLink replies with a valid or
invalid checksum by sending back the
EEPROM Checksum Status
EEPROM Checksum Status
EEPROM Checksum Status
EEPROM Checksum Status
command.
Example: 8D|00|00|8D (There are no Data bytes for this command)
EEPROM Checksum Status: 8E|01|00|01|8E
2.1.9
2.1.9
2.1.9
2.1.9
EEPROM Checksum Status
EEPROM Checksum Status
EEPROM Checksum Status
EEPROM Checksum Status
A ConnexLink issues this command to the Host in response to a
Check EEPROM Checksum
Check EEPROM Checksum
Check EEPROM Checksum
Check EEPROM Checksum
command. A Data value of 00h indicates an invalid Checksum while a value of 01h indicates a
valid Checksum.