12 mm from the top drill rear end of fuselage with 2 mm for
elevator control.
Insert snake inner R 19 through rear end of fuselage and
through horizontal slot in former R 9. Apply glue to pushrod
housing at rear end of fuselage only and cut off flush with
fuselage. Do not apply glue to slot in former R 9!
7
Install elevator servo in servo tray and drill
mounting holes for servo.
Install pushrod connector R 25 to servo horn and
install servo. Note that servo horn faces forward in
installed position. This will enable you to adjust
pushrod or remove servo horn through opening in
former R 6.
8
Carefully sand top and bottom
contact surfaces of fuselage, then
sheet top and bottom of fuselage
with R 20 (3 mm balsa), grain
crosswise.
Attention:
Do not sheet contact
surface of tailplane!
9
Sand front of fuselage flush with R 3 (A or B) and glue in place
R 11 A or R 11 B (1 mm birch ply), depending on type of motor.
Make sure to match motor mounting holes in R 11 with holes in
R 3!
Note:
Depending on diameter of spinner and type of prop
adapter used it may be necessary to glue R 21 (A or B) to the
front of R 11 (A or B). Make sure openings for cooling air and
motor mounting screws match those of R 11.
10
R 19
R 20
R 20
R 11 A
R 21 A
R 21 B
R 11 B
i
