Glue in place top wing sheeting panels F 13 and
F 14 (1.5 mm balsa). Fit and glue in place F 13
first.
Attention:
The rear end of F 13 must coincide
with centre line of wing spar. Remove residual
glue immediately to provide a good contact
surface for F 14.
Fit and glue in place webs V 1 to V 3 between ribs
F 1 to F 4. Glue in place lower wing spar F 11
(5×2 mm spruce).
Glue servo trays F 15 in rib bays between ribs F 3
and F 4 to upper spruce spar and to top sheeting.
Align servos parallel with rear edge of wing and
glue in place on servo trays.
19
21
When glue has completely dried, carefully remove wing
from jig and turn upside down.
Cut off tabs with modeller´s knife or razor saw and sand
lightly.
Into rear sheeting panels F 14 cut slots for servo horns
and openings for servo leads as shown.
Glue in place sheeting panels F 13 and F 14.
20
22
F 13
F 14
F 11
V 1
V 2
V 3
F 3
F 1
F 4
F 15
F 14
F 13
