Carefully sand rear edge of wings flush with ribs. Trial-fit
trailing edges F 16 and cut contact surfaces at wing
centre to appropriate angle. Then glue trailing edges in
place and secure with tape.
Carefully sand top and bottom wing sheeting flush with
end ribs. Wing tips consist of 4 pieces F 17 each. Glue
together, then glue to end ribs.
When dry, sand wing tips and leading edge to shape
and give complete wing a smooth surface.
23
Position wing on fuselage and align centre lines of wing and fuselage. Drill
with 4 mm through wing and R 7 for M4 wing bolt F 19.
Redrill R 7 with 5 mm. From below insert nut R 24 in R 7 and glue in place
with epoxy.
Glue reinforcement F 21 (1 mm birch ply) to top side of
wing. Make sure that holes in wing and reinforcement
match perfectly.
25
26
Position wing on fuselage, if necessary correct cut-
out in canopy. Drill with 4 mm through leading edge
for wing dowel F 18.
Insert wing dowel in wing and check wing position
when dowel is seated in former R 4. Correct, if
necessary, then glue dowel in place.
24
F 16
F 18
F 17
R 7
F 21
R 24
Note:
Bottom view; fuselage side
panel omitted for clarity.
i
