44
IFCLITY1106 - 5773010_01
- Choose the place for unit installation
according to the layout of the room, the
number of units to be installed, and any
limitations imposed by the architecture.
Check the chosen place is suitable for
installation and maintenance work on
the unit.
- Install four M8 threaded rods into the
ceiling to hold the frame.
To install the FCLI unit, proceed as
follows:
- upturn the box of the FCLI cassette-type
fan coil
- open the cardboard box
- remove the box; you are advised to
make cuts on the corners of the box
and remove the cardboard in separate
pieces
- remove the upper part of the packaging
frame (that protects the unit during
transportation)
- remove the fan grille and take out the
Inverter
- reassemble the fan grille
- assemble the Inverter on the bracket
- If it is necessary to fit any accessories
(fresh air kit or delivery to an adjacent
room, hot water valve), carry out these
operations before installing the machine
on the ceiling.
WARNING:
consult the relevant
manuals of the accessories
Do not handle the unit using the water
connections; use the specific brackets
for this purpose.
- lift the unit carefully by means of
the brackets and, keeping it slightly
inclined, attach it to the 4 threaded
bars using 8 nuts (4 of which are self-
locking). Use the nuts to adjust the
height of the unit; finally, check that the
unit is installed in a horizontal position
- feed the hydraulic pipes through the
suspended ceiling to the attachment
plate on the unit
- make the plumbing connections as
described in the relative chapter
- Take the condensate discharge piping
to the relative fitting on the attachment
plate
- bleed the system (the drain valve for
the 2-pipe circuit is on the outside of
the attachment plate). The drain valve
for the heat circuit of 4-pipe systems
is inside (to access it, remove the
polystyrene tray)
- make the condensate drainage
connection as described in the relative
chapter
- The electric box is supplied with the
grille accessory (GLLI - GLLI_N).
- bring the power supply and command
cables close to the electric box; ensure
the cables are long enough to follow
the movement of the electric box on
the guides during the assembly and
disassembly phases
- connect the Inverter to the electric box,
using the cables supplied
- consult the manuals of the grille
accessories; the instructions for
assembling and connecting the electric
box can be found in the manual
supplied with the grille accessory
- After completing the connections and
inserting the electric box in its seat in
the FCLI unit, fix it with the two screws.
WARNING: fix the safety cable to
the fixing screw of the electric box (to
the side of the water connections). The
snap-hook of the safety cable must then
be connected to the grille frame.
-
The grille frame must be positioned so
that the glass with the AERMEC logo is
in line with the corner of the electric
box
.
- Fix the grille to the safety cable.
- Fix the grille with the 4 screws.
WARNING!! Tighten the screws
with a maximum tightening torque
of 0.45 Nm. You are advised to use a
screwdriver. Do not use non-calibrated
electric screwdrivers. The tray will be
irreparably damaged if tightened too far.
- Remove the suction grille by means of
the two ¼ turn bolts.
- Assemble the air filter.
- Reassemble the suction grille by means
of the two ¼ turn bolts.
- adjust the position of the unit from the
support bracket by means of the nuts so
that the unit is level and the frame rests
slightly on the suspended ceiling
- start the fan coil unit and carry out
an operation test; the functions are
described in the User Manual
INSTALLING THE "MODULE 600" UNIT
