TRANSPORT AND INSTALLATION
Page 18 of 32
Connecting the pump-out kit
CAUTION
Damage to appliance due to improper installation
Never push the pump-out kit into the air dehumidifier
using power / force.
Never tighten turn locks using power / force.
1. Remove the water collecting tank from the air dehumidifier.
In the water tank compartment you will find a plug socket with an AMP
dummy plug inserted (Fig. 2, item 5).
2. Remove this AMP dummy plug from the socket and keep it in a safe place.
It is required for operating the air dehumidifier without pump-out kit!
3. Connect the AMP plug of the pump-out kit to the socket in the dehumidifier.
4. Ensure that the turn lock
has been turned fully to the left (horizontal
position). The bottom rabbet of the pump-out kit rear wall must engage in the
bottom edge of the water tank compartment.
5. Put the pump-out kit into the water tank compartment.
The pump-out kit can be positioned in the water tank compartment without
effort in such a way that the rear panel is flush with the casing.
6. Turn the turn lock clockwise until the pump-out kit is firmly mounted in the
water tank compartment.
The turn lock must turn easily, otherwise the pump-out kit is not in its correct
position!
7. Connect a drain hose to the drain pipe and lay it from the air dehumidifier to
an outlet or to the outside. The air dehumidifier is ready for operation with the
pump function. The pump used is designed for a maximum height difference
of 4 metres.
