MODULEX EXT 321, 481, 641, 802, 962, 1123 BOILERS
Installation, Operation & Maintenance Manual
OMM-0087_0F
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
Page
11
of
146
GF-143
Phone: 800-526-0288
07/13/15
1.8 Operational Requirements
General Requirements
1.8.1
The following instructions MUST be followed:
•
The boiler must only be used for its designated purpose as described in these Installation
Instructions.
•
Each unit is fitted with a data plate. Consult the details on this plate to verify whether the boiler
is compliant with its intended location, e.g.: gas type, power source and venting classification.
•
Only use the boiler with the accessories and spare parts listed.
•
Other combinations of accessories and products must only be used if they are specifically
designed for the intended application and do not affect the system performance or the safety
requirements.
•
Maintenance and repairs must only be performed by trained professionals.
•
Installation of a condensing gas boiler must be approved per all federal and local government
codes, regulations, and laws.
•
Operation of a condensing gas boiler must use a vent system that has been specifically
designed and approved for this type of boiler.
•
Note that local permission and approval for the vent system and condensate water connection
to a public sewage system may be required.
Regulatory Requirements
1.8.2
You must also conform to any rules, regulations, or laws concerning the following:
•
Local building codes regarding the installation.
•
Local building codes concerning the air intake and outlet systems and the vent connection.
•
Regulations for the power supply connection.
•
Technical rules laid down by the gas utility company concerning the connection of the gas
connection to the local gas mains.
•
Instructions and standards concerning the safety equipment for the water/space heating
system.
•
Installation instructions for building heating systems.
•
The boiler must be located in an area where leakage of the boiler or connections will not result
in damage to the area adjacent to the boiler or to lower floors of the structure. When such
locations cannot be avoided, it is recommended that a suitable drain pan be installed under
the boiler.
•
Do not restrict or seal any air intake or outlet openings.
•
If you find any defects, you must inform the owner, in writing, of the system defect and the
associated hazard.
