AM Series Cascade Sequencer User Manual
Page
8
of
28
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
OMM-0101_0D
04/29/2016
Ph.: 800-526-0288
GF-146-CS
1.3 Preparing the Cascade Sequencer for Use
The Cascade Sequencer is used to program the logic address of each heater, as well as control
the final cascade system, and must be wired as described below.
Preparing the Cascade Sequencer for Use
1. Using a small flat head screwdriver, remove the rear cover of the Cascade Sequencer by
levering up the panel via the slot, as shown in Figure 1-4.
Figure 1-4: Opening Rear Panel of Cascade Sequencer
2. Connect two wires, each two feet (0.5m) long, to the two screw terminals on the Cascade
Sequencer PCB, as shown in Figure 1-5. Wires do not have polarity.
Figure 1-5: Connecting Wires to the Cascade Sequencer Terminals
3. Feed both wires through the rear panel conduit opening and snap rear panel onto rear of
cascade Sequencer (Figure 1-6).
Figure 1-6: Replacing Rear Panel after Wiring
Using Screwdriver
in Slot
Cascade
Sequencer
Rear Panel
Install Wires into Terminals