MIUM0018_REV06_ QRCE_20180312-MIUM-ENG-AQ AQ_001523_02_0721
9
ENG
3.3 Check at reception
Upon reception of the unit, we suggest that a complete control is carried out, to verify that the unit is intact and complete,
and no damage has been sustained during transport. Any eventual damage revealed must be communicated to the carrier,
demonstrating the reserve clause within the transport documents, specifying the type of damage.
3.4 Storage
In the event that received unit is not sent to installation place directly but stored, it shall be stored in its package in a dry
place, far from sun, rain, heat sources, sand and wind.
Comply with the storage conditions given below :
• do not stack the units over the limit described on previous par. 3.1
• environment temperature range : min -20°C ÷ max +60°C
The Manufacturer declines any responsibility for damage due to a bad storage.
4
–
I
NSTALLATION
&
C
ONNECTION
4.1 Definitions
CUSTOMER
– The Customer is the person, activity or the society, that has bought or hired the unit, and intends to utilize
the machinery for its intended use.
USER / OPERATOR
– The User or Operator is the actual person that has been authorized by the Customer to utilize the
unit.
QUALIFIED PERSONNEL
- Defined as the person who has followed a relevant specific course of study, and so is able to
understand the dangers derived from the use of the machinery, and in turn, due to this, are capable of solving major
dilemmas.
Safety regulations
•
Qualified personnel must carry out the installation.
•
During the installation operation, use protective clothing.
•
During the installation operate in absolute security, pollution free air and in an area free of obstructions.
•
Respect the regulations in force in the country in which the apparatus is being installed. Specifically relative to its
use, and to the disposal of packing and products used for the cleaning and maintenance of the unit. Respect the
recommendations given by the producers of such products.
•
Avoid contact with moving/rotating parts.
•
In the event of scheduled or not scheduled maintenance, first disconnect power supply.
•
The maintenance and the substitution of damaged or consumed parts must be carried out only by specialized
personnel, following the indications found within this manual.
•
Spare parts must correspond to the requirements specified by Manufacturer.
N.B.
The installer and the user of the apparatus must take into account, and solve problems, connected with any other
type of risk that may occur to the unit. For example, risks derived from the entrance of foreign bodies, or risks due to the
presence of flammable or toxic gas.
The Manufacturer declines any responsibility for failure to respect the Safety Regulations and the prevention
as described below.
Furthermore, the Manufacturer declines any responsibility for damage caused by the improper use of the unit
and/or modifications carried out without proper authorisation.
