AEQ
PHOENIX ALIO
29
The left zone shows the general status of both communications channels, PROGRAM (PRG)
and COORDINATION (CRD) (CONNECTED, OK, REGISTERING, etc), as well as the
configured working mode and encoding and the remote equipment’s data (IP address and port
or name) in case it is connected. We can click in any of both areas in order to show a window
that provides all the details of the channel we have clicked on:
•
INTERFACE: indicates the operating mode of the channel (RTP Raw, DIRECT SIP or
Proxy SIP)
•
Coding: indicates the coding algorithm or profile: OPUS, G711, G722, MPEG L2, <SIP
CODEC PROFILE>… This section also indicates binary rate (128 Kbps for example),
the sampling frequency (48 KHz, for example) and the mode (Mono, Stereo, Dual,
JStereo or MS Stereo).
•
Status: SIP registering status for IP connections using Proxy SIP mode
("REGISTERING", "REGISTRATION_ERROR", "REGISTERED") or interface status
("OK", "CONNECTED", "CONNECTED_NO_DATA / NO_SYNC").
•
CONNECTED TO: calling/called equipment’s name or number (identifier, number or
Unknown when ID is not provided) or "not connected" when there is no established
communication.
The lower part of the individual codec window identifies each unit by its given name, IP address
and each channel URIs (identifier for SIP calls) for each of both channels:
On the right part, for both channels, PROGRAM and COORDINATION, we can find the "CALL"
button/indicator and the "SYNC" indicator, as well as two audio presence indicators for both
directions: transmission ("Tx") and reception ("Rx").
4.1.1. CONFIG Menu.
At the right side, "CONFIG" button gives access to a configuration menu with the following
options: "General", "Contacts", "Ethernet", "Miscellaneous" and "Network".
Just click on "CONFIG" button again in order to close this menu.