AEQ
Audio Over IP
Routing System
119
The configuration options are as follows (the last 2 are displayed only when the option is
enabled):
o
"Disable": to deactivate it.
o
"16 Channels" (for CAPITOL IP): activates it with a maximum of 16 channels.
o
"32 Channels" (for FORUM): for the activation of a single FR14 module in slot 14, with
a maximum of 32 channels.
o
"64 Channels" (for FORUM): for the activation of two FR14 modules, one in slot 14 and
the other in 13, with a maximum of 64 channels.
o
"Sync": allows you to configure whether the console will use the synchronism extracted
from AoIP link ("Slave"; slot 14 prevails over slot 13 in FORUM console) or not
("Master").
o
"Used": allows you to configure how many of the available mono channels are actually
in use.
AES: this tab appears only in CAPITOL and allows you to configure if you want to synchronize
the console using the external synchronism received in AES11 format through AES3/SPDIF
digital audio input 1: in that case, you must configure this option as "Slave". It’s not possible to
use WORD CLOCK external synchronism.
"VIRTUAL GPI" and "VIRTUAL GPO" options, at the bottom of "Internal Module/Virtual -
Configuration" submenu, allow you to configure the virtual GPIOs of the console. For more
information, please consult the user's manual of the unit.
FORUM EXTERNAL SYNC.
There is an independent RJ45
connector for external sync input
(AES11 or Word Clock) in the
common inputs and outputs module
at the back panel, including a
follower
synchronization
output
(AES11 or Word Clock) independent
of the rest of digital outputs (see user
manual for the product).
If a valid external AES11 or Word
Clock
synchronization
signal
is
present, this one prevails over the
external sync configuration on multichannel link (MADI or AoIP). If this signal is not present,
then the external synchronization can be obtained from the multichannel link (MADI or AoIP) by
configuring the "Slave" mode in the corresponding tab.
If the "Master" mode is selected in the multichannel link tab and there is no external sync input,
then local synchronization is selected using the console internal oscillator.