green and then LED will pulse a blue.If fail, the yellow LED lasts for 30 seconds, then the
greenLED flashes once.
figure1
8. TriSensor can be installed on a flat surface such as a shelf, in a corner or on a wall using the
Back-Mount Arm, or within a ceiling or wall using its Recessor accessory (sold separately). If
using the Back-Mount Arm;
a. Screw Back-Mount Arm into the corresponding threaded hole on the back of TriSensor.
b. Affix Back-Mount Arm to your desired location using the provided double-sided tape or
KA2.5×20 mm screws.
c. Angle the TriSensor as desired.
Get help & learn more.
Should you encounter any problem with TriSensor, visit http://support.aeotec.com/trisensor or contact
our support team via aeotec.com/contact. You can also learn more about TriSensor features,
configuration options, and technical specifications at the link.
Gateway compatibility.
To see if this device is known to be compatible with your Z-Wave gateway, please refer to
http://aeotec.com/z-wave-gateways
Declaration of Conformity.
Aeotec Limited declares that TriSensor is in compliance with the essential requirements and other
relevant provisions of RED 2014/53/EU, RoHS 2011/65/EU, IEC62321:2008 and EN50581:2012.
Command Class Configuration
The device supports the controller to configure parameters of the device through Configuration
Command Class, and the device has 21 parameters available for users to set according to their
different needs:
