17/06/2021
Water Sensor 7 Pro user guide (ZWA019/ZWA044) : Aeotec Help Desk
https://help.aeotec.com/support/solutions/articles/6000235950-water-sensor-7-pro-user-guide-zwa019-zwa044-
5/9
Tampering
If either Tamper Switch 1 or 2 is activated the device blinks red
one time with ½ second duty cycle if within range of Controller.
The device blinks red three times with ½ second duty cycle if out of
range of Controller
Water protection
When operation button is Short Pressed the LED illuminates red
three seconds in case of Water Leakage detected and Green if
no Leakage detected.
Button Function.
Push Type
Function
Description
Long Press 5s
Pending reset
LEDs start indication Waiting for Reset.
Long Press 10s
Reset
Initiates Device Reset Locally.
Short Press
Tamper
Sends Wake Up notification.
3 Times Short Press
Sequence
See Learn Mode.
Advanced Functions.
Communication test.
This utilizes the Power Level command class to determine the health between the Water Sensor 7 and your Z-Wave
gateway. This will tell you if the Water Sensor 7 has a healthy connection to your system and is a great method of
debugging connectivity issues.
1. Set Parameter #4 to value #1
2. Double click the Tamper Switch.
3. Result:
Green LED blinks once -
success
Red LED blinks 3x times -
failure
Firmware-Update over the Air.
This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the
central controller. Once the controller starts the update process, perform the following action to confirm the firmware
update:
1. Wake Up the device by removing the cover.
2. Hit the tamper switch once.
Send a wake-up notification.
In order to send your sensors new configuration commands from your Z-Wave controller or gateway, it will need to be
woken up.
1. Wake Up the device by removing the cover.
2. Hit the tamper switch once.
