Product Usage
Once the device is powered up it will start monitoring the air parameters and warn of mould using the local red
and green LED. All air parameters are measured every 15 minutes. Pushing the button will force an immediate
measurement and the LEDs will indicate the danger of mould
•
green: no danger of mould in the room
•
red: danger of mould, open the windows to lower the humidity
The device contains two sensors with the following accuracy measures:
•
Relative Humidity: precision ± 3% RH (max), range 0 to 80% RH
•
Temperature: precision ±0.4 °C (max), range 0 to 65 °C
•
Dew Point: precision ±0.4 °C (max), range 0 to 65 °C (calculated from other sensor values)
The device sends the following notifications to the central controller:
•
Weather Alarm - Moisture Alarm(0x10 - 0x02)
•
Power management - Replace battery now(0x08 - 0x0b)
•
Heat Alarm - Overheat Unknown Location(0x04 - 0x02)
•
Heat Alarm - Underheat Unknown Location(0x04 - 0x05)
For get the status of the device on the network you need insert a battery to device. And you see result: - "The
GREEN LED will blink one time in case of success or RED LED will blink five times in case of failure".
Quick trouble shooting
Here are a few hints for network installation if things dont work as expected.
1. Make sure a device is in factory reset state before including. In doubt exclude before include.
2. If inclusion still fails, check if both devices use the same frequency.
3. Remove all dead devices from associations. Otherwise you will see severe delays.
4. Never use sleeping battery devices without a central controller.
5. Dont poll FLIRS devices.
6. Make sure to have enough mains powered device to benefit from the meshing
Firmware-Update over the Air
This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by
the central controller. Once the controller starts the update process, perform the following action to confirm the
firmware update: Wake Up the device by pressing the central button once.
Association - one device controls an other device
Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device
is called association. In order to control a different device, the controlling device needs to maintain a list of
devices that will receive controlling commands. These lists are called association groups and they are always
related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored
in the respective association group will receive the same wireless command wireless command, typically a
'Basic Set' Command.
Association Groups:
Group Number
Maximum
Nodes
Description
1
5
Lifeline
2
5
High Temperature Notification
