IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 the value sent in the application shall be the
desired value minus 256. For example: To set a parameter to 200
it may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the
same logic applies: Values greater than 32768 may needed to be given as negative values too.
Parameter 3: Current Overload Protection.
Over current protection. Output load will be closed after 30 seconds if the current exceeds (US: 15.5A, AU or EU: 10.5A)
Size: 1 Byte, Default Value: 1
Setting
Description
0
Disable
1
Enable
Parameter 4: Overheat protection.
Output Load will be turned off automatically after 30 seconds and if the temperature of product inside exceeds 100°C.
Size: 1 Byte, Default Value: 0
Setting
Description
0
Disable
1
Enable
Parameter 20: Configure the output status after re-power on it.
Configure the output status after re-power on it.
Size: 1 Byte, Default Value: 0
Setting
Description
0
Last status
1
Always on
2
Always off
Parameter 80: To set which notification would be sent to the associated devices (Group 1)
To set which notification would be sent to the associated devices (Group 1) when the state of Nano Dimmers load is changed.
Size: 1 Byte, Default Value: 0
Setting
Description
0
Send Nothing
1
Send Hail CC
2
Send Basic CC report
3
Send Multilevel Switch report
4
Send Hail CC when using the manual switch to change the load state.
Parameter 81: To set which notification would be sent to the associated nodes in association group 3
To set which notification would be sent to the associated nodes in association Group 3 when using the external switch 1 to switch the loads.
Size: 1 Byte, Default Value: 1
Setting
Description
0
Send Nothing
1
Send Basic Set CC
Parameter 82: To set which notification would be sent to the associated nodes in association group 4
To set which notification would be sent to the associated nodes in association Group 4 when using the external switch 2 to switch the loads.
Size: 1 Byte, Default Value: 1
Setting
Description
0
Send Nothing
1
Send Basic Set CC
Parameter 83: Configure the state of LED
Configure the state of LED when it is in 3 modes
Size: 1 Byte, Default Value: 0
