Remove your Door / Window Sensor 7 Pro from Z-Wave network.
Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main
controller/gateway. To do this, please refer to the part of your gateway's respective manual that tells you how to remove
devices from your network.
1.
Set your Z-Wave controller into unpair mode.
2.
Triple-click the tamper switch on Door / Window Sensor 7 within 1.5 seconds.
3.
After a successful exclusion, it will green light up its LED for 2 seconds then deactivate.
Reset your Door / Windows Sensor 7 Pro.
This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used
when the primary controller is inoperable.
To manually factory reset:
1.
Remove the cover of Door / Window Sensor 7
2.
Press and hold tamper switch for 5 seconds until the red LED blinks.
3.
Release the tamper switch
4.
Immediately press and hold the tamper switch again, a green LED will confirm reset
Association Groups.
Association groups allow Door Window Sensor 7 to directly control Z-Wave devices without the use of a Z-Wave
Controller to maximize communication efficiency.
By default, Group 1 is assigned to Node Id 01 during the pairing process of your Door / Window Sensor 7 to determine
where it should report its sensor reports to.
Group
Number
Maximum
Nodes
Description
1
5
Lifeline
2
5
Control devices when a magnet or external dry contacts trips
3
5
Sends our alarm message when magnet controlled or external dry
sensor trips.
4
5
Sends alarm messages when tamper is tripped
5
5
Control devices when tilting sensor trips
Parameter Configurations.
Parameter 1: Operation Mode.
Aeotec Door/Windows Sensor 7 Pro User guide : Aeotec Help Desk
https://aeotec.freshdesk.com/support/solutions/articles/6000230465
9 z 14
23. 2. 2021, 19:15
