AENO ARC0002S, User Manual, Page: 11 / 144

11
To remove the dust container from the cleaner, press down on the dust
container lock (see figure e) and pull it out of the cleaner. Take the water
container , turn it over, open its lid, fill the container at least 2/3 full of clean
water and close the lid (see figure f). Attach the floor-cleaning cloth to the
bottom of the water container. Then replace the dust container with the water
container. The vacuum cleaner is ready for wet cleaning. Additionally, you can
control the water supply via the AENO app.
WARNING! Do not use the vacuum cleaner in wet cleaning mode to clean
carpets.
Vacuum cleaner maintenance
The side brushes
can be washed with hot water or cleaned with a damp
cloth. To clean the dust container, remove it from the vacuum cleaner by
pulling down on the lock
. Then open the rear lid of the dust container and
shake the rubbish and dust out into the rubbish bin (see figure g). Open the
top lid of the container and take out the HEPA filter
. Clean the filter and
container with the vacuum cleaner maintenance brush or a dry cloth. The
water container and the floor-cleaning cloth can be cleaned with water. The
roller brush
(see figure c) can be cleaned with the vacuum cleaner
maintenance brush provided that you remove the roller brush from the
body of the device by releasing the two locks (see figure h).
WARNING! Never wash the dust container, HEPA filter and roller brush with
water.
Troubleshooting
1. The vacuum cleaner does not turn on. Possible reasons and solution: Make
sure that the START/STOP button
is on, the vacuum cleaner is charged,
and the room temperature is between 0 °C and +40 °C. Try turning the