NTX VHF FM Series Remote Mount Transceiver
SM28 Installation and Operation Manual
May 9, 2012 Rev: 5.00
Page 2-1
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Section 2.0 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation procedures,
post-installation checks, and installation drawings.
2.2
Unpacking and Inspection
Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each unit should have the following:
- NTX VHF FM Series Remote Mount Transceiver
- Product Information Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately to your supplier.
2.2.1 Warranty
All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website
www.aem-corp.com/warranty for complete details.
2.3 Installation
Procedures
2.3.1 Warnings
Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any logic, audio, or DC
power lines from this unit with 400 Hz synchro wiring or AC power lines. Do not position this unit next to
any device with a strong alternating magnetic field such as an inverter or significant interference to
operation will result. In all installations, use shielded cable exactly as shown and ground as
indicated. Significant problems may result if these guidelines are not followed.
2.3.2 Cautions
Severe degradation of audio installations may result from incorrect wiring and shielding. This could
cause much higher cross-talk, hum, and ground-loop interference.
2.3.3 Notes
For maximum resistance to low frequency interference, electrically ground the case of the
transceiver.
