5
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until
instructed to do so.
a) Use the supplied zip-tie to secure the throttle cable
to the main wiring harness. Remove the bolt securing
the coolant temp sensor bracket to the top of the
thermostat housing as shown.
b) Check to see that the inside of the AEM
®
intake
inlet pipe and air filter are clean and free from any
foreign objects and/or obstructions. Install the 2.5”-
2.75” silicone reducer over the throttle body end of
the intake pipe using the 2.5” hose clamp.
c) Install the previously removed MAF sensor into the
intake pipe using the two supplied allen bolts.
d) Install the 2.75” side of the silicone reducer over the
throttle body. Install the supplied 3/8” breather hose
onto both the valve cover nipple and the pipe nipple,
secure with supplied ¾” hose clamps. Secure the
intake pipe bracket using the supplied M6 washer and
M6 bolt.
Bolt
Bracket
