8
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed
to do so.
b. Locate the driver side fog light bracket. It is clipped onto the front bumper. Remove the three mounting screws shown
in the photos.
c. With the foglight removed from the bumper, bend
the fog light bracket in the orientation shown in the
diagram.
d. Insert the ½” hose (5-5016) onto the crankcase,
securing with the 1” hose clamp. Leave the other end
open for now.
e. Place the reducer coupler (5-323) onto the throttle
body with the smaller side over the throttle body. Se-
cure the smaller side of the coupler with the provided
hose clamp (9444).
f. Apply the rubber edge trim onto the frame rail as
indicated.
